 |
Name: Exterior Joinery
Specifications: Curved Solid Yellow Cedar Components..
Description: Glazing Bars & Beads... Yellow Cedar |
 |
Name: Door Glazing Beads
Specifications: Bentwood / Machined Glazing beads
Description: Profiles bent to suit shape, then sliced and machined to suit client specifications..
These product are 15x12mm; 21x9mm however all profiles are manufactured on request..
Present volumes exceed 6000 units per mth. Our technology and skills allow for large volume production |
 |
Name: Double Mitre Saw
Specifications: Mitre Saw for Auto or manual Mouldings
|
 |
Name: Bentwood Glazing Beads
Specifications: Pressed, Sliced Vusa Vusa
Description: Here pressings have been sliced ready for machining and sanding |
 |
Name: Joinery components
Specifications: Bent Yellow Cedar [40x45] Component
Description: Timber Supplied by Herman Pacific |
 |
Name: Door Mouldings
Specifications: NZ Pine Machined Mouldings
Description: just one of many profiled Mouldings... our speciality is the machining, painting and mitring to length. Supplied in Packed in Boxes and shipped off-shore... large volumes |
 |
Name: Door Mouldings
Specifications: NZ Pine Machined Mouldings
Description: `These have been painted, supplied in Mitred lengths ready for installation... Precision cutting achieving 1000's of components |
 |
Name: Moulded Sheet MDF
Specifications: 3mm MDF impregnated and moulded to shape
Description: A total of 75 secs to this stage.. impregnation and pressing using 60 kw of Heat very rapid processing |
 |
Name: Laminated Jigging -- Door Beads
Specifications: XV7 * XR6 laminated systems
Description: 9 & 14mm product; XV7 has an inside radius of 2.5mm pre-bending is required even for a 1.6mm veneer
Shell size produced 300 width, ripping to 14 & 21mm as finished width of products |
 |
Name: Post Bending of Solid MDF
Specifications: R&D impregnation of Sheet MDF and shaping
Description: In this case 9 & 12mm MDF was impregnated and pressed onto a jig.. minimum radii 9mm I/D radius |
 |
Name: 3mm Flat MDF
Specifications: Impregnated, pressed 76sec
Description: Pressed to shape MDF 3mm. Within a batch cycle this product can be produced in 76 seconds..
Regular 3mm board cut to size, impregnated and pressed/extruded
Different thicknesses possible with varying degrees of precision. This process can produce 'Patterned Doorskins' say
810 x 2.1m, 'Wall & Ceiling Panels' etc.. pressures required approx 15lbs per sq inch, very low, heat drying either by Oil, or RF. Multi daylight or single presses with very low capital cost.
Technology available to volume uses.. present product used for Kitchen Doors & or Ceiling/Wall Panels |
 |
Name: Door Jambs
Specifications: NZ Pine ; Variety of sizes, profiles and packing system
Description: Product is CTL, and Packed before arriving here in Australia for routering and adding hinges |
|
